: Power off the device and connect it to the PC using a USB cable while holding the required boot keys (often Volume Up/Down) to enter BROM/EDL/Vcom mode .
Issue: Device not recognized by PC
| Symptom | Probable Cause | Solution | |---------|----------------|----------| | DUT cannot register to tester | ARFCN mismatch or wrong band | Verify band config in NVRAM | | High BER in RX test | Poor RF cabling or mismatch | Check VSWR, use attenuators | | Catcher shows no logs | UART baud rate mismatch | Set 921600, 8N1, no flow control | | Power ramp fails mask | PA ramp profile incorrect | Re-run META TX calibration | MTK GSM LABORATORY V1.0
The MTK GSM LABORATORY V1.0 represents a significant milestone in standardizing MediaTek hardware diagnostics. By consolidating flashing, calibration, and protocol analysis into a single controlled environment, it significantly reduces troubleshooting time for field engineers. While V1.0 focuses on core GSM functionality and stability, future updates are expected to expand capabilities into 4G LTE and 5G NR analysis. MTK GSM LABORATORY V1
: It is often distributed as a compressed RAR file that requires extraction. Users must install the correct MTK USB drivers (available within the software package) to ensure the PC recognizes the phone in Flash/Vcom mode. Operational Guide Launch : Run MTKTool.exe with administrative privileges. While V1
La certification qualité a été délivrée au titre de la catégorie
« ACTIONS FORMATION »
© Seela – 24/11/2022
Organisme de formation
N°11755030075
Cet enregistrement ne vaut pas agrément de l’Etat.
Le certificat Qualiopi est disponible sur ce lien
A propos
Ressources
Le groupe
Une question ?
information@seela.io
Si vous avez des besoins d’adaptation en lien avec un handicap, contactez notre mission handicap à l’adresse suivante : inclusion@seela.io
