Point-n-measure Digital Tape W5746 User Manual May 2026

The Point-N-Measure Digital Tape W5746 features a 3-second power button hold for operation, auto-shutoff after 150 seconds, and requires 1.5V AAA batteries. It offers single-distance laser measurement, area/volume calculations, and unit switching between meters, feet, and inches, alongside a physical steel tape with a locking mechanism. For full operating instructions, see the 1pc Laser Tape Measure User Manual Alleenonline.nl Digital Measuring Tape - Alleenonline.nl

7. Understanding the LCD Display Icons

Functions:

Use the mode buttons (often labeled for Area or Volume) to toggle between simple distance and calculated square/cubic footage. Point-N-Measure Digital Tape W5746 User Manual

Adding / Subtracting Distances

Targeting:

Point the laser at the far wall or surface you wish to measure. The Point-N-Measure Digital Tape W5746 features a 3-second

"Err" Message:

This usually means the device is too close to a surface (under 2 feet) or the signal is being absorbed by a soft surface (like curtains). Try measuring against a solid, flat wall. Dual Measurement: Switch between Laser Mode and Tape Mode

  • Dual Measurement: Switch between Laser Mode and Tape Mode.
  • Multiple Units: Meters (m), Feet (ft), and Inches (in).
  • Calculation Modes: Single distance, Area, and Volume.
  • Auto-Correction: Automatically calculates Pythagorean measurements (indirect measuring).
  • Data Hold: Freezes the measurement on the screen.

Q: Can I store measurements for later recall? A: Yes, the device can store up to 20 measurements for later recall.

To get the most out of your Point-N-Measure Digital Tape W5746, follow these tips and best practices:

Scroll to Top