Narco Escort Ii Installation Manual [exclusive] Full May 2026
Narco Escort II is a specialized, lightweight "shared system" avionics radio designed for light aircraft. Unlike standard dual-function units, it can operate as either a NAV receiver or a COMM transceiver, but not simultaneously. System Specifications Approximately 3 pounds. COMM Capability: 720-channel transceiver. NAV Capability: 200-channel VOR/LOC receiver.
- Receive (Standby): Approximately 0.5 Amps.
- Receive (Squelch Broken): Approximately 0.7 Amps.
- Transmit: Approximately 4.0 Amps (peak).
Cable Type:
Use RG-58 A/U 50-ohm coaxial cable. Keep lengths under 9 feet to minimize signal loss (less than 2 dB attenuation).
Intercom Setup
: An Intercom Key function is available via Pin 12. When this pin is externally grounded through a switch, the microphone audio bypasses the transmitter and is amplified for cabin use. 5. System Calibration and Testing narco escort ii installation manual full
Electrical Pinout and Wiring (P301 Connector)
The unit is designed for cabin environments in fixed or rotary-wing aircraft. It typically operates on a 14V DC system, though 28V installations are possible with a dedicated power converter.
Call to Action:
If you are an A&P or experimental builder, consider scanning your paper Escort II manual and submitting it to the Internet Archive. Your contribution could save a fellow aviator from an incomplete installation and a potential emergency in the air. Narco Escort II is a specialized, lightweight "shared
Mounting
: Antennas must be electrically connected to the aircraft ground plane. For composite or thin-skinned aircraft, a doubler plate is required for structural integrity and electrical performance. Intercom and Audio Setup The Escort II includes a built-in 50 mW audio amplifier.
Intercom Key
: An intercom function is available on Pin 12. When this pin is grounded through an external switch while the mike key line is open, audio from the microphone bypasses the transmitter and is heard through the headphones. Receive (Standby): Approximately 0
Completing Installation
: Once the installation bar completes, you may be prompted to restart your computer or directly launch the application.